English Views: 0 Author: Site Editor Publish Time: 2023-09-04 Origin: Site
The disassembly methods of tire changers can be divided into the disassembly and assembly methods of flat-bottom rim tires and the disassembly and assembly methods of deep-set tires. The following is a detailed introduction to the disassembly and assembly methods of flat-bottom rim tires and their installation methods. I hope you found this information helpful.
l Method for disassembling flat rim tires
l Method for mounting flat rim tires
Flat-rim tires are used to fasten the tire to the rim with a pressure ring and a strip. So the ring tire is easy to remove from the rim once the strip is removed. First, place the dismantled tire on the moving pallet of the tire changer, with the side with the strip facing outward. Clamp the tire onto the gripper by the above-mentioned method, make the tire rise to the working height and completely release the air in the tire. Adjust the disassembly position, and roll the disassembly disc at both sides of the tire respectively (apply brush grease on the tire side, tire mouth, and rim with a brush) to loosen the tire mouth, press ring, and strip. Stop the rotation of the tire by hand prying up the opening of the clamping bar, so that the disassembling disc along the top of the prying bar rotates the clamping claw to make the tire rotate, and the clamping bar can be removed. This operation should be especially careful to prevent the sudden pop of the strip stop the tire rotation, remove the pressure ring, push the inner tube valve nozzle to the rim groove, and then move the disassembly rod to the left working card slot, adjust the height and distance, use the disk to extrude the tire rim, tire all removed.
When installing a tire on a flat rim, put the inside of the tire changer and fill it with air. Clamp the rim on the clamping claw according to the above-mentioned method, place the tire on the movable pallet, adjust the height of the clamping claw (rim), move the distance of the pallet, install the valve nozzle in the mouth slot of the rim, then move the pallet to make the tire set into the rim, place the pressure ring and the clamping strip, and then roll the clamping strip on the rim with the disassembling disc. At this time see whether the pressure strip, or pressure ring is completely stuck into the rim groove, the tire down on the trawl, release the claw to move the trawl outwards and push the tire down. Tire loading is complete.
The procedure for the disassembly and installation of the deep-set tire is the same, and you can follow the above steps.
YANTAI JINTUO AUTOMOBILE TECHNOLOGY CO., LTD. is a company specializing in the production of tire changers. The company has a group of professionals, you can consider buying our company's products.