What Are The Tips for Using The Tire Changer?

Tire changer is the necessory repair equipment for 4 s shops and auto repair shop and tire shops, and car maintenance in the use of tire changer, there will be a few tricks. Here is a simple description of the tire removal machine with the use of tips, hope to provide information to help you.

Here is the content list:

l For rubber tops good but soft and thin tires

l For sports cars with long tires

l For tires with hard tread

l Tire removal head scraping steel ring

For rubber tops good but soft and thin tires

When you use the tool to shovel the tire, you can slightly lift the control pedal of the tire changer and push the tire inwards to confirm the contact between the shovel edge and the tire edge. Then stand with your legs or hands to prevent the tire from falling back, and then step on the control pedal, which is easier to remove the tire.

For sports cars with long tires

The tire is affected by the internal air pressure for a long time, and the heat generated by the friction between the tire and the ground leads to the adhesion between the tire and the underwire. If it is difficult to disassemble the shovel, you can dissolve the dishwashing detergent in water and apply more solution to the tire lip and underwire with a small brush. After the solution penetrates the gap between the tire lip and the underwire, the tire changer shovel can be used to scoop down the tire.

For tires with hard tread

It is best to choose the trolley spring plate when removing the tire, and it is easier to make a homemade long crowbar to pry the bird's head to the mouth. When the tire is on, press the tire belly with both hands. When the difference is about 200mm and the tire mouth is at the tightest point, press the tire belly with the right elbow. At the same time, push the tire clockwise with the left hand, which can prevent the motor and the triangle belt from slipping, but also protect the tire changer motor.

Tire removal head scraping steel ring

When the hexagonal pin lock is not tight, the screw of the dismantling head is loose or the direction is wrong, or the gap between the hexagonal pillar and the hexagonal sleeve is large, the problem of scraping the steel ring of the dismantling head may occur. If the hexagonal column lock is not tight, you can first loosen the screw, repeated the adjustment, can lock the hexagonal column so far. If the dismounting head screws are loose, preinstall the screws and then install the screws. When installing the screws, a medium-sized tire should be installed, so that the dismounting head roller rests on the steel ring, turn the direction of the dismounting head to make it consistent with the arc of the steel ring, then tighten, and finally tighten. If you use the hand to pull the hexagonal column, the swing is relatively large, replace the tire changer's arm.

These are a few tips for using the tire changer, which you can use as desired.

YANTAI JINTUO AUTOMOBILE TECHNOLOGY CO., LTD. is committed to the research and production of a tire changer, if you want to buy it, you can contact us.